Hi,
my printer is Da Vinci 1.0A, but still i cannot print using simplify 3d, after submitting the job. it just stop. and nothing will happen,
Any tips and advice please.
-
JJ Viernes
- Posts: 1
- Joined: Sun Dec 13, 2015 9:44 pm
-
CompoundCarl
- Posts: 2005
- Joined: Wed Aug 05, 2015 7:23 am
Re: cannot print using simplify 3d
Are you using the stock S3D profile for the da Vinci 1.0? It works fine for me.
Perhaps you can attach the .3w file you created with Simplify3D so someone else can test on their printer.
Perhaps you can attach the .3w file you created with Simplify3D so someone else can test on their printer.
-
JoshuaYates
- Posts: 31
- Joined: Wed Jul 08, 2015 10:17 am
Re: cannot print using simplify 3d
Are you sure your printer is connected correctly?
Are you able to control your printer using the machine controller built into the software?
Are you able to control your printer using the machine controller built into the software?
Re: cannot print using simplify 3d
in the scripts tab, in post processing on a new line after the prepend command try adding:
{REPLACE "\n" "\r\n"}
see if that helps
{REPLACE "\n" "\r\n"}
see if that helps
