Hi. In slic3r I can use modifiers to get, for example, different % of infill in the same object. Can this be done with simplify3d?
Also, Can I print different layer hights in the same object? In slic3r I can configure for example to print some layers of 0.2 and then print in the same object some layers of , for example, 0.1 Can this be done in simplify3d?
Thanks in advance
-
tinchus2009
- Posts: 1
- Joined: Fri Dec 18, 2015 8:17 pm
-
CompoundCarl
- Posts: 2005
- Joined: Wed Aug 05, 2015 7:23 am
Re: Different infill % in the same object
Yes, read this: https://www.simplify3d.com/support/tuto ... f-a-model/
If you want it to only apply to a specific region, then you just need to create 2 separate STL files. You can do this in any CAD package using boolean operations.
If you want it to only apply to a specific region, then you just need to create 2 separate STL files. You can do this in any CAD package using boolean operations.
