S3RIOUS74 wrote:I have the axiom and I am printing successfully with Simplify3D. I used the start and end Gcode from cura (same as from astroprint). The only thing I added was a move over in the X direction after auto leveling. Otherwise the nozzle will crash into the build tray retaining rail when it goes to print. Then I just used the same material settings (speeds, temps, retraction, etc.) that I was using in cura, and I was good to go.
Hope that helps.
Hi, just started using the AXIOM and used the same settings from CURA in to S3D. IT seems to be going OK but I'm struggling to get a decent top finish. Has anyone had anything similar?