Corkscrew / vase method - Malyan M180

[Birdman1]

I have the following issue, object is a hollow cube from 20*20 mm 0,4 mm thick ( so single layer)
want to print this in the corkscrew method, the box is checked but it keeps printing back and forward, i don't see where i went wrong.
In attachment my print profile,
remark
I change every 100 layers to a lower temperature.
spend hours on how to solve this without any change to my issue
Anybody that can set me on the road;0))

thx

[CompoundCarl]

Try the same settings but with a SOLID 20x20mm cube (not a hollow one). The vase mode setting will only print the outer-most perimeter, so you don't need to use a hollow model as well.