Sub division of speed

[Rebekah_harper]

I have had an issue with the additional features.

I can't seem sort out the speed suitable for some of my prints.

I was thinking the addition of a whole new tab to sit along with the extruder, infill, support, other etc...

'Speed' having the ability to override the automatic speed settings. setting the speeds for different layers.

but I understand the need to have the auto setting for the speed. therefore I would like to add a return to auto setting after a pre-set layer set by the user.

so setting layer 1 to 50mm/s then setting layer 5 to 20mm/s then setting layer 10 to auto (this being a return to software set speeds)

this would help a lot with large prints which also have some smaller areas requiring some more delicate approach.

kind regards

Rebekah Anderson