Heated bed plate settings acting squirrly on Replicator 2

[SHoutzager]

I added a heated bed plate to my Makerbot Replicator 2 and then altered S3D with these settings. http://3dprinting-blog.com/498-how-to-u ... implify3d/

The first print worked well and the plate heated up first. Now I am unable to get the plate to heat up. Nearly every time that I go to my Firmware Configuration settings S3D will have snapped back Replicator 2 default instead of Replicator with HBP. I will reset it and hit Save.

I added the GCode and I know that it has worked once.

The plate works because I can heat it up thru the control panel on the replicator.

Best!

S.Houtzager

[CompoundCarl]

You probably have your process settings set to override the firmware configuration. So you need to make the GPX change directly in your process settings (on the G-Code tab).

You can learn more about this here: https://www.youtube.com/watch?v=NYPUAqT4UyI

[SHoutzager]

That did the trick, so far!