Settings changes for quality change

[pinthenet]

I have been printing for a few months @0.2mm (Vertex K8400) and I've tuned the process settings to get reasonable to good results. I'd now like to do some printing @0.1mm and I am assuming I can't just change the layer height alone, and that some settings will need to be adjusted. Is this summarised anywhere?

Thanks for any pointers
John

[AreDigg]

As long as your printer are able to print it, layer height should be the only option. However you may or should also need to double the initial layer height setting.

[MartinNicolay]

Hi John,

i just startet to use Simplify3D with my K8400.
It is a great pice of Software but the results are not as good as it was with the cura engine.
so it would be nice if you can share the settings u made with me/us?

Thanks in advance

Martin