Changing default extruder temperature

[root]

I want to change the default extruder temperature? In my firmware it is set at 200C. But I want to change it so that it holds for the whole print.
In the Temperature tab of FFF (Process) Settings...I set the Layer 1 setpoint to my new temp (see attached). Is that enough for all layers of the whole print?

Thanks for any help!

[CompoundCarl]

Yes, since you only have one setpoint, if you change the temperature for layer 1 it will set the temp at layer 1 and then remain constant for the entire print.

[root]

Yes, since you only have one setpoint, if you change the temperature for layer 1 it will set the temp at layer 1 and then remain constant for the entire print.

Thanks !!