Firmware configuration error pop-up

[ItsBigRob]

Since updating the software I have notice this message every time I boot up to start a new print.

Error Pop-Up



This does not stop me from doing anything that is necessary. Just happens each time I open up S3D and start a print. (More Annoying than annything)

Any guidance would be appreciated.

[CompoundCarl]

That probably means your processes have the firmware override enabled and that's different than the settings you currently have in Tools > Firmware Configuration. They have a video that explains this more: https://www.youtube.com/watch?v=NYPUAqT4UyI

[ItsBigRob]

That probably means your processes have the firmware override enabled and that's different than the settings you currently have in Tools > Firmware Configuration. They have a video that explains this more: https://www.youtube.com/watch?v=NYPUAqT4UyI

Thanks just after i had posted it I was tinkering around and fount that option. The video was really helpful too thanks for the link