problem with bottom layer quality on support

[imunozf]

Hi, i'm from chile and i need help.

when i print with support, the part of the piece that's in contact with the support, has a very low resolution, instead the rest of the piece has a very high resolution.
i dont know wich part of the configuration i do wrong to obtain the same quality in all the piece.

I have a leapfrog creatr.

salutes!

[CompoundCarl]

There's lots of similar threads on here already
viewtopic.php?f=9&t=5029
viewtopic.php?f=9&t=5275
viewtopic.php?f=8&t=4453

[MontyFlange]

and my thread.

It's terrible now, It was great before these 'updates'.

viewtopic.php?f=9&t=5516

[Rebekah_harper]

if you add dense support layers then open the gcode file in notepad.

"ctrl F" search for dense and change the speed to 1000 or so.

i get pretty good bottom layers as the dense support layer acts like a good base

[MontyFlange]

I use 3GX not sure I can alter that. I'll go back to using V2 I think. It was great with that version.

[MontyFlange]

Back to V 2 for me. This came out perfect compaird to V3

Exactly the same settings