By the way this is PLA. I can post the settings if needed.
Thanks
20160712_194044 by michael32766, on FlickrRough Surface from supports
Hi, I've been getting a rough surface where the support structures are. They come off ok but still leave a bit of a mess. The upper surface is fine. What settings do I need to adjust to clean this up.
By the way this is PLA. I can post the settings if needed.
Thanks
20160712_194044 by michael32766, on Flickr
By the way this is PLA. I can post the settings if needed.
Thanks
20160712_194044 by michael32766, on Flickr-
CompoundCarl
- Posts: 2005
- Joined: Wed Aug 05, 2015 7:23 am
Re: Rough Surface from supports
There has to be 10 other threads about this exact topic from the last month. See if you can search and find some similar topics.
Re: Rough Surface from supports
Thank you I appreciate your taking time to answer. I looked at the printing trouble shooting guide and did a search for "Supports". That search unfortunately came back with 98 pages and 972 posts.
I'm trying to narrow it down a bit.
Does the issue come from the Horizontal offset from part or the support pillar resolution?
Thanks,
I'm trying to narrow it down a bit.
Does the issue come from the Horizontal offset from part or the support pillar resolution?
Thanks,
-
CompoundCarl
- Posts: 2005
- Joined: Wed Aug 05, 2015 7:23 am
