change start stop location with only perimeter printed.

[twofieros]

I have a very thin walled model that prints fine with just a single perimeter and zero infill. For cosmetic reasons I want to make the program start and stop each layer on the inside. Since there is no infill and there is only a single perimeter printing I'm unable to figure out how to tell S3D to start and stop on the inside perimeter. This model has a crucial part located on the inside perimeter and labels on the outside. If it wasn't for the inside part I thought I could redo the model to be solid and just choose two perimeter walls but that would not work. Does anyone have any suggestions?

[dorsai3d]

Vase mode? Or the Layer tab option "Choose start point closest to specific location" might work, depending on what you're looking to accomplish.

[twofieros]

perhaps the location thing will work. I'll try that and report back.

[twofieros]

It took some time but I was able to solve this when printing two models but if I add more than that it returns to the initial problem.