Posts: 4
Joined: Fri Jul 22, 2016 7:54 am

Vase mode issue

Fri Jul 22, 2016 8:33 am


I want to print this vase but looking at it sliced it looks like to be partly vase and regular printing. Even there is no islands or very steep overhangs. I even ran it through Meshmixer to see if it could repair anything.

Attached GCODE
(4.62 MiB) Downloaded 125 times

Posts: 2005
Joined: Wed Aug 05, 2015 7:23 am

Re: Vase mode issue

Sat Jul 23, 2016 7:59 am

It always switches back to normal layer-by-layer printing if the layer can't be printed with case mode. For example, if you have multiple islands or other features that can't be printed in a single spiral. So I expect there is a feature in the STL file that is preventing it from printing in a continuous spiral.

Posts: 237
Joined: Mon Jan 11, 2016 9:01 am

Re: Vase mode issue

Sun Jul 24, 2016 11:05 pm

Yeah, it looks to me like it's switching to non-vase mode because the overhangs there are way too steep. The filament on one layer's perimeter wouldn't be touching the layer below when printing, which isn't going to work...

Posts: 4
Joined: Fri Jul 22, 2016 7:54 am

Re: Vase mode issue

Wed Jul 27, 2016 6:44 am

Could it help to use a wider nozzle and wider wall width?

And/or slim the vase by scaling only XY?

Need to try this when I get home.

User avatar
Posts: 1124
Joined: Wed Aug 28, 2013 11:02 pm
Location: mullica, nj
Contact: Website

Re: Vase mode issue

Sat Jul 30, 2016 10:36 pm

dorsai has it right on. the problem here is that the perimeter is stepping over so far that there is a gap it needs to fill. you can A, lower the layer height, B, increase extrusion width. probably best to do a combination of both.

Return to “Troubleshooting and Bug Reports”