Help to remove blobs

[macpit]

Hi there,

I have a new CoreXY printer, direct E3D Titan Extruder and E3D V6 Hotend, my Filament i have tested is ABS.
The Firmware is Repetier dev Version with advance mode Disabled.

Now i have a lot of blobs and can't remove them. Days of prints but no solution to remove the blobs.

Maybe some one can help me to solve this issue.

80mm circle Debug.factory

(18.25 KiB) Downloaded 127 times

Regards

Mac

[CompoundCarl]

I would suggest starting here: https://www.simplify3d.com/support/prin ... s-and-zits


It covers pretty much all of the suggestions I can think of

[dorsai3d]

It's also possible that your ABS is wet and those blobs are defects from the water evaporating and pushing out filament or bubbling on extrusion.