Hey
Long time user of simplify 3D, fantastic software.
I have however run into something I need help with. See the bellow pictures, the tooling path doesn't run strokes across the whole base, it skips a few sections then goes back over them.
This causes viable markings on the bottom 1st layer of my print where it skipped sections and went back later in the layer run to fill them in.
How do I setup simplify 3D to make sure that first layer does strokes all the way across without starting and stopping in sections? I need a uniform first layer!
[img][img]https://s15.postimg.org/b9ozkqajr/1st_Layer.png[/img][/img]
