Robo3D R1 Plus settings

[lassehknudsen]

Greetings,
is there a guide somewhere that shows how to use the Simplify3D with a Robo3D that has autoleveling? I would like the same ease of use as with mattercontrol, atleast for starters.

I coould start the print from mattercontrol, but the problem is that it was midair printing, so the result was not what is was hoping for

Searches for this has yielded many possible answers, but with older posts, im not sure if i can trust them.

next, how do i stop a print from the Simplify3D gui, i could not find it.

-lasse

[CompoundCarl]

I think you can just go to Help > Configuration Assistant and load their stock Robo3D R1+ profile. Shouldn't need to do anything else.

As for stopping a print, if you go to Tools > Machine Control Panel, you have a lot more options for monitoring and controlling the printer

[njpl]

Same issue here. I tried what Compound Carl posted, went to Help > Configuration Assistant and chose ROBO 3D R1+, but I still get the mid-air printing on job start. I'm pretty new to this, so I'm digging for any suggestions on how to get S3D to accept the auto leveling settings from the R3DR1+. Thank You.

[dorsai3d]

Try the couple of things at the bottom of this thread: viewtopic.php?f=9&t=6336