Sorry it took so long was out of town.
Attached is my 100micon .fff file I used to print the owl.
http://www.thingiverse.com/thing:18271
I printed it at 33% size its 1.92" tall
Some notes:
1. I have only got it tuned for PLA I will work on the ABS next.
2. I do run the PLA a little hot but it helps with the flow.
3. The way it is configured it will not slice a feature smaller than 1mm (.039")
4. You probably don't want to under fill at this thickness. It has caused some problems.
I will be happy to share what I have learned just ask.
I wish I was better at taking pictures as the photo doesn't do it justice.
- OWL printed at .100 mm layer thickness.
- .100 owl.jpg (174.86 KiB) Viewed 273336 times
- 100micron.zip
- 100 micron layer thickenss profile.
- (1.02 KiB) Downloaded 495 times
Feedback welcome.