foobiwan wrote:Funny. My FF Creator Pro is now 2 Weeks old. Send directly from China.
It does not have the fan and also not the cable for it in the harness.
Where did you buy it? FF USA?
I'm an Australian Flashforge reseller so I purchased directly; I imagine they were going through the last of the older models via their own store, however I was given the option of receiving the revised version.
It screws into the holes on the left hand side of the aluminium block/bar that the heater blocks mount below; it's super useful for PLA as it prevents/reduces the warping and curl when printing overhangs.