[OK] Filling holes whereas I don't want it

[Cashandrick]

Hi,

I have some issue with a print with Simplify.

I want to print this file : http://www.thingiverse.com/thing:2017614/#made

I dont understand why, when i simulate the print, the software adds layers that I dont want, and fills all the whole.

Have some idea?

There is the screenshot of the simulation

[dkightley]

Same issue as this: viewtopic.php?f=9&t=7008

And the same solution will apply....

[brian442]

It's probably an issue with the original STL file. Did you try running the repair checks in S3D to see if it found non-manifold or self-intersecting surfaces? If so, you need to repair the model first.

[Cashandrick]

Ok, that's weird. Be repairing it wasn't as i wanted. I downloaded agin the stl, i reopened it, and this time all was right.