[ADDED] Printing a raft just under support structures

[RobotWorkshop]

I've been printing on glass quite a bit and it would be nice to be able to use a raft just under the support material going from the build plate. Is there a way to do that now that I've missed? If not I think this would be a great feature to add.

[brian442]

Read this:
viewtopic.php?f=23&t=5475&start=20#p29116

[S3D-Jason]

Version 4.0 added the ability to print raft base layers, which will create solid layers at the very bottom of your support structures. You can also add a brim to hold these solid layers down even more, or add a raft below that if you need even more adhesion. This has made a big difference in the success of the support structures for some of the tall prints that we have done, so thanks for the great suggestion!