GE Jet engine stator upgrade slicing issue

[llange]

Hello all !
I'm tring to slice those parts ( http://www.thingiverse.com/thing:410218 ) but S3D is not slicing it fully, only the blades. Even rotating 90 deg. those parts it can't slice correctly
With CuraEngine I can slice correctly. Meshmixer found no errors in those parts.
I'm using layer height of 0,1mm, but even changing it there is no improvement.
Any light ?
Thank you !

[brian442]

Is it possible that the hub is thinner than your nozzle diameter? If so, you will need to lower your extrusion width in the software if you want to print it correctly.

I think they talk about it more here:
https://www.simplify3d.com/support/prin ... ng-printed

[dkightley]

If it is thin walls, see this thread as well: viewtopic.php?f=23&t=3471