TCP Streaming for printer control

[laubed]

Hi,

the smoothieboard features a telnet console that acts like a serial interface. However Simplify3D printer control does not support tcp streaming mode.
I would like to get this feature added so i can control my printer with only one software.

Thanks in advance,
Daniel Laube

[Lightning]

Hi,

this feature would be very nice!
Hope this will bee implemented.

Greetings
Stefan

[lukenrd]

This feature would be great. It would allow me to control my Kossel which uses the Duet ethernet controller with Reprap firmware. It supports http, ftp and telnet and works with Repetier Host through telnet (port 23).

Thanks,