Setting up E3D Cyclops heater (Dual extruder, single heater)

[martin1454]

Hello -

I have been trying to find the correct way to setup an E3D cyclops - It can do dual extrusion with a single nozzle / heater

- But when i configure my printer as an dual extruder printer, in the temperature tab, the extruder 1 and 2 have diffrent tempetrature designators, and it will not allow me to have them as the same designator - What to do?

[Kaidk]

I would like an answer, too.

[rrdavis]

Just delete the extra temperature controller and then you will only have 1 temperature controller for the single heater