smarcus3
Posts: 13
Joined: Sun Aug 27, 2017 4:33 pm

PTFE infill issues

I'm having problems with my infill filaments breaking and then causing more infill areas to become messed up as shown below.
I'm printing at 35mm/s at 240F in PETG.

Image
smarcus3
Posts: 13
Joined: Sun Aug 27, 2017 4:33 pm

Re: PTFE infill issues

to help another user in the future, this was fixed by increasing the infill extrusion width to 125%. After that its been clear skys.

Return to “General Discussion and Tips”