Posts: 7
Joined: Sat May 27, 2017 11:15 pm

Machine Z and Software Z

Sun Oct 08, 2017 8:39 am

Been trying to figure this part out.

When setting up a new machine for the first time, do I need to setup Z on the machine first, or do I just set everything on the software ?

Since what I have today is first layer height at 1% and the machine set a 0.865.

Feels like am doing something wrong ?

In other words the software controls everything on the machine I just set it up on the software other than the calibration when first booting the machine.

Prusa i3 Mk2s


Return to “Troubleshooting and Bug Reports”