Thin top layers

[RBomboy]

See the swirls on the shoulders?

Hello,

I'm somewhat new to 3D printing. I'm using Simplify3D for slicing with my Flashforge Creator Pro 3D Printer.

I'm seeing a top layer print too thin. See attached image.

I especially see this when I use the any infill at 20% other than rectilinear.

[brian442]

Probably want to start by reading this:
https://www.simplify3d.com/support/prin ... top-layers

[dkightley]

Another idea not yet included in the link referenced above....try using the Variable Settings feature to split the settings into layers so you can have a low infill for the lower part of the body, and then increase the infill at the shoulders, etc.

[RBomboy]

Probably want to start by reading this:
https://www.simplify3d.com/support/prin ... top-layers

Found this after, thanks! I'm going to try to increase the top layers.