Has anyone else experienced overall "jitterness" to theirs prints? Especially when printing ooze shield? I never had these issue before and when I use flash print (software that comes with the machine) the prints are nice and smooth.
I contacted S3D and they told me the ooze shield jitter is a known issue and told me to slow the speed down for it. (this is a OK temp fix but not a permanent one and also doesn't remove all the jitterness)
After observing the prints, it jitters when laying down the single fill extrusion also.
All this vibration is not good for the machine.
Also, for some strange reason the prints starts before the skirt prints?! This defeats the purpose.
I am running the latest firmware and S3D 4.0