I'm sure you are printing to hot - and with a to large LayerHigh which is added to the distance between nozzle and bed.
This distanz is unknown for S3S, you must adjust it with the settings for the FirstLayer.
Read this : https://forum.simplify3d.com/viewtopic.php?f=8&t=1941
The interruption with the blue marked blobb shows it: the nozzle is leaking extremly because
-the material is to liquid (low viscosity)
-the distance between the nozzle and the bed is to large, the material can easy soak outside by the consequence that the nozzle is empty
The bad sticking of the oval object may have different reasons.
My favorite is that the extrusion is clogging of the filament inside the heat block because heat is rising up (by to high temperature - and / or - to low feeding, because the melting process is also a cooling process for the feeder tube).
But additionally it is also possible the nozzle is clawing the print bed caused by
- distorted by bed-heating (we are speaking about 0.1 - 0.2 mm!) to understand as a bulge also as a bumb
- the objekt is laying crooked on the bed; to be controlled with the view of the underside (diving down) and with slicing a skirt to the object without a distance, than the skirt must follow the objects outside line exactly, Any undercutting of the object shows it.
Your settings for the FirtLayer were 90% LayerHigh and 100% Extrusion = 0.40 mm
The FirstLayerHigh cause a distance of 90% of given LayerHigh (0.2 mm) = 0.18 mm + the distance nozzle-bed = ~ 0.15 mm summary ~ 0.33. These void is to be filled with your 100 % extrusion saying the same quantity to the nearly double space. Than the nozzle is not able to press material to the bed with a fine adhesion and the rope is pulled away.
The calculated quantity is depending from the LayerHigh and the ExtrusionWidth and it determies the position of the lines to be printed. Therefore I use th possibility of the G-Code-settings with a negative value (mostly -0.05 mm = 30% of my layer high of 0.15) and this has no influence to line position and the quantity to be extruded, it brings only more material to the bed because the gap is lower.
Your retract settings are depending from your extruder system - direct extruder.
Using Coast (stopps the feeding before reaching the end of line but leks out material) and
Wipe goes back the nozzle the given distance (without feeding but leaks as long as pressure is existing)
all together makes the nozzle empty, follwed by the retract. If a positive RestartDistance is needed is also a question how much material is leaking while the printhead is travelling.
Test it out with out any retracting and / or check on the box at menue Advanced .. Only Retract when ...