hi guys, went searching for my exact issue and couldnt find it anywhere.
Anyways, when rendering a bridged perimeter Simplify3d doesnt apply ALL of the bridging settings to the perimeters......specifically the extra inflation distance
as per below
biggest drama about this is the nozzle doesnt have time to ease the pressure inside before reaching the bridge resulting in a drooping perimeter, ontop of that my fan isnt fully upto speed till the nozzle is a few mm's into bridge also adding to the problem.
if the inflation distance was honoured by the perimeters i feel theyd be time for the process to be ready for the bridge and a non droopy perimeter.
**for clarity the infill part of the bridge prints perfectly fine**
regards
Gav