I have attached a photo. The one on the bottom is my prototype. The one on the top is my print. It's as if the surface layer was not even printed(?) I left some of the support in place to show what it was like.
Print Quality Issue Where Supports Were Attached
My first print with S3D came out rather well, except for where supports were attached. I used default settings since I am brand new to S3D.
I have attached a photo. The one on the bottom is my prototype. The one on the top is my print. It's as if the surface layer was not even printed(?) I left some of the support in place to show what it was like.
I have attached a photo. The one on the bottom is my prototype. The one on the top is my print. It's as if the surface layer was not even printed(?) I left some of the support in place to show what it was like.
Re: Print Quality Issue Where Supports Were Attached
There is a good section with info about this here: https://www.simplify3d.com/support/prin ... e-supports
