Ranom pauses during print

[subspace3d]

I did have the wait for temperature to stabilize checked and did uncheck it, and for a while I didnt see any pauses on the designs I was printing.

However, recently I'm seeing them again so although in certain circumstances it will contribute, it seems there are others which can cause pauses.

My issue is now fixed. It was caused by the firmware "losing it's mind" while trying to calculate tip offsets for multi extrusion. i went into Marlin and "commented out" the hot-end offset in the firmware and have it in the slicer now. works great. If you are running offset hot-ends id try to do that and see if it works.

While I have two nozzles, I actually only print with the one (T0 Left). The offset is -25 in the X axis for T1 in S3D and apply toolhead off-sets to g-code coordinates is selected. If I'm not actually using T1 at all I'm guessing this is not the cause for my other pauses I'm seeing?