In the photo below, note the high frequency (yellow? green? - I'm color-deficient and can't tell) fill on either side of the internal infill. Two questions:
1) Why is it there? It wastes a ton of print time time and beats the crap out of my printer, and it sure looks like it could/should be deleted and the actual internal infill expanded slightly to replace it.
2) What is it? When I try to match the color to the key (again, I'm color-deficient), it looks like it is supposed to be a bridge. Which makes no sense because the layer below it is solid.
I've tried every setting I can imagine might have something to so with this and can't make it go away. Any help very much appreciated!!!