Which printer to select to setup for CTC?

[gtoal]

The CTC dual-extruder printer is not listed in the setup wizard. Should I set up using "Other" or "Flashforge Creator Dual"? (or something else)

Looking forward to getting started, I've adjusted the CTC's lop-sided nozzles already, and levelled the bed, I just need the software now...

Graham

[Joey]

I think using the Flashforge Creator profile or Wanhao Duplicator profiles would work just fine. Sine they're all clones of the Replicator I don't see it being an issue. If the bed size or print dimensions are different you'll need to change that, but for most printing it should be fine.

[MasterFX]

You can chose either the Flashforge Dual or Makerbot Replicator 1 Dual. Works well for me