Anyway, I found this tool change script on the forum that I'm hoping is a good one (tho not exactly sure considering all the variables... ):
Code: Select all
{IF NEWTOOL=0} T0 ; Start tool switch 0
{IF NEWTOOL=0} G1 X[next_position_x] Y[next_position_y] F[travel_speed] ; move to next printing location
{IF NEWTOOL=0} G1 Z[next_position_z] F1002
{IF NEWTOOL=0} G1 E0 F[toolchange_retract_speed] ; prime new tool
{IF NEWTOOL=1} T1 ` ; Start tool switch 1
{IF NEWTOOL=1} G1 X[next_position_x] Y[next_position_y] F[travel_speed] ; move to next printing location
{IF NEWTOOL=1} G1 Z[next_position_z] F1002
{IF NEWTOOL=1} G1 E0 F[toolchange_retract_speed] ; prime new tool
G92 E0
Anyway, would love any input/advice you guys may have. I'm running RepRap Firmware on a Duet Wifi on a custom CoreXY build... and currently have 2 Titan extruders setup as bowden to a Cyclops (2 in 1 out) hotend... though considering trying a different style 2 in 1 out hotend as well (NF TH-01 I believe is the model... but will worry about that another time)