(dual posting on Lulzbot community)
Needing a slicer that works with our TAZ6 and not having the time to wait for Cura LE 3 to stabilise, we bought a licensense for S3D but the flexy dually V2 tool head does not actually seem to be supported out of the box?
-
JohnyWalter
- Posts: 12
- Joined: Wed Jul 11, 2018 7:10 am
Re: Support for TAZ6 w. Flexy dually V2 tool head
This seems to be the closest forum topic, despite being a few years old - I apologize in advance.
New TAZ6, brand new wen FlexyDually v2. Fully mounted, remains loose in the "v" hanger.
Able to nudge the entire head, by gently lifting the front edge, a couple mm, as if the ledge lip is too big, or the head catch is too small, or they are not matching in their profile.There is too much "play" in the mount.
I feel that the head should be snug and not move, even a little but, independently from the mount, nestled in and torqued properly.
Is this common or typical? Should I just pad it with material and then go to leveling process?
New TAZ6, brand new wen FlexyDually v2. Fully mounted, remains loose in the "v" hanger.
Able to nudge the entire head, by gently lifting the front edge, a couple mm, as if the ledge lip is too big, or the head catch is too small, or they are not matching in their profile.There is too much "play" in the mount.
I feel that the head should be snug and not move, even a little but, independently from the mount, nestled in and torqued properly.
Is this common or typical? Should I just pad it with material and then go to leveling process?
