DarthRevan wrote: ↑
Fri Jul 27, 2018 1:57 pm
Either of you guys have a good profile for all of these advanced materials with this printer? I might get one based off of it's proposed ability to handle these harder to print with materials.
I'm still finding out best settings myself. The shop I bought the printer from have some very very good test demo prints in Nylon and PC, large and small.
The Intamsys Material Guide from their website shows the starting settings recommended for each filament type, but for ABS type the shop and myself agree the E fan should be off not on like it says on the guide.
I've just switched to PC from ABS, and the first print was OK. If anything it's S3D limiting the result, as S3D is not using my best bridging settings when it should. If it was then PC would be better than ABS.