Support for Bits from Bytes Rapman

[Stefan328]

Hello,

i have an 3D Printer calles Rapman form BFB. The company was bought from 3D Systems. Now they don`t have any further support.
But a lot of people have already a Rapman. Might be some thousands.

At the moment i use Kissslicer to make my gcode files.
The problem is that vor Rapman some special things are needed like the file must be written .bfb and not gcode and also some other specials.

Could anyone help me with that or does somebody already tried it?

Attached is a gcode done by Kissslicer that works fine and one version done with Simplify3D that is not working.

Best regards
Stefan