Does anyone else get annoyed by the rotating of the "workspace"?
It seems as if the pivot point is always the same no matter where the cursor is. This means that if you are zoomed in on a small part and go to rotate, the part goes off the screen and you have to pan to find it again.
Shouldn't it be like all other 3d software where the pivot point is the same location as the cursor?
That way if you click on the part and rotate, you actually are rotating around the part, not the whole workspace.
Can this be "corrected"?? (Does seem like a mistake to me)
Re: Rotate pivot point
Thanks for your interest in this existing feature request. Please continue discussion of this feature request in the linked thread.
"A bird does not sing because it has an answer. It sings because it has a song."
