I have a Monoprice Ultimate (Wanhao Duplicator 6) that I cannot get S3d to slice well. I end up with what appears to be oozing on short lines/curves. I have went through the troubleshooting guide and really have not been able to improve much. I have changed so many things a fff file is not feasible.
Really seems that retraction is not working in S3d
I have attached the header from the gcode I created yesterday as well as an A/B image. I downloaded Cura and setup the basics .2 layer height 70mm/sec 205/60 temps and printed, the results are remarkably different, Cura is better.
Here is a pic to l
