After having tried to use Variable Settings Wizard to change layer height on a critical part of my model, I am now faced with the problem that no matter what I try, the Print Preview will only show my model up to about where I originally cut my model.
I have tried to delete the factory processes and create just a single on, but so far in vain.
What could be causing this?
Re: Variable Settings Wizard bug?
Advanced tab.....uncheck the "Stop Printing at Height" box.
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Re: Variable Settings Wizard bug?
That was it! Thank you.
