AndersE
Posts: 224
Joined: Sun Feb 02, 2014 4:40 pm

Hangs in mid print with smoothieware/board.

i have a delta that runs smoothie, and i sometimes in 4.1.1 it stops printing. Using the "force next" works, but it will blob if i am not at the printer.

Have never happened before on earlier releases.

No error in communication window is reported.
rrdavis
Posts: 421
Joined: Sat Dec 09, 2017 4:52 am

Re: Hangs in mid print with smoothieware/board.

If you print the same gcode file a second time, does it hang in the same place? Can you attach the gcode file?
AndersE
Posts: 224
Joined: Sun Feb 02, 2014 4:40 pm

Re: Hangs in mid print with smoothieware/board.

yes, it stops at the same place every time. I attach factoryfile.

It stops at the bottomleft cutout on the perimeters when laying the first layer..

This is not the one i complained about, but another i just found out.

I have checked the part with netfabb basic and it report no errors.
Attachments
base2+3+4.factory
(42.77 KiB) Downloaded 234 times
AndersE
Posts: 224
Joined: Sun Feb 02, 2014 4:40 pm

Re: Hangs in mid print with smoothieware/board.

I have been printing some more now, and it soes not matter what i print. There is this hang (continue possible) in the beginning of all prints.

I have NOT changed anything on my computer, no updated firmwares or changes to configs for the smoothieboard.

Every single print it happens. No errors in the log at all.
User avatar
DarthRevan
Posts: 480
Joined: Wed Feb 18, 2015 8:29 am

Re: Hangs in mid print with smoothieware/board.

I remember reading previously that smoothie had problems with densely packed movement commands. Do you have firmware updates available? There seem to be a high number of retractions on your first layer. Have you tried changing your advanced retraction settings to see if that makes a difference?

Return to “Troubleshooting and Bug Reports”