vandel212
Posts: 5
Joined: Thu Jan 10, 2019 10:19 pm

Z-Axes out of sync

Thu Jan 10, 2019 10:28 pm

Hi, I have a Robo 3D R1+, and I'm using the default S3D profile for it. When I finish a print, I notice that my X Gantry is way out of level. The right side is visibly higher than the left side. So much so that it wont even auto-level on the next print. What that tells me is during the print, the Right z-axis is moving up faster than the left.

I do not believe this is a hardware issue, as when I use the Craftware slicer, it works properly (I tried the same model with both slicers). Is there a setting or something I need to adjust in Simplify3D to get this to print properly?

S3D-Jake
Posts: 494
Joined: Wed Jun 20, 2018 11:45 am

Re: Z-Axes out of sync

Fri Jan 11, 2019 10:00 am

Please attach your G-Code that is working, and then one from Simplify3D that is showing the issue when you try to run it.
"A bird does not sing because it has an answer. It sings because it has a song."

vandel212
Posts: 5
Joined: Thu Jan 10, 2019 10:19 pm

Re: Z-Axes out of sync

Fri Jan 11, 2019 11:36 am

S3D-Jake wrote: Please attach your G-Code that is working, and then one from Simplify3D that is showing the issue when you try to run it.

Sure thing, here you go. Thanks!
Attachments
Z_Axis_gcode.zip
(1.94 MiB) Downloaded 8 times

vandel212
Posts: 5
Joined: Thu Jan 10, 2019 10:19 pm

Re: Z-Axes out of sync

Sun Jan 13, 2019 4:47 pm

Does anyone have any thoughts on this? This issue basically makes it impossible for me to print anything, and I'm all out of ideas.

Return to “Troubleshooting and Bug Reports”