Having a wee problem. I swear this worked fine in the past but it seems to be broken now.
hoping I can get it working again as I use it VERY extensively.
I will slice a model and set up multiple VS's processes.
what I then do is I go into all the secondary processes and I delete the hot end, heated bed, and cooling parameters. just straight up remove them.
this is critical. I will use this same gcode on multiple machines for multiple materials.
so I will start the print and then manually "set" my desired hot end temp bed temp and fan temp (if I want other than what its sliced for) on the printer itself.
this is why its critical to DELETE those temperature units in the secondary processes otherwise when the printer gets to that layer height it will "reset" my manually set parameters with the once in the gcode.
but if I DELETE those entirely in the secondary processes "nothing" resets the settings and it holds the settings I manually configured at the beginning of the print.
for example I might slice if for 220c 60c 100% (hot end bed and fan)
but now I want to print with proto pasta so I will change the 220c to 235c manually. if I left those configured in the secondary processes it would "reset" to 220c when it got to the next process.
if I want to print abs I will manually reset to 255c 120c 0% or petg 255c 90c 25%
all in the same gcode file.
this appears not to work anymore. simplify 3d is "adding back into" my processes default values (200 60 100) not even what I configured.
OK small update. it appears it DOES properly save my gcode the way I want it (no temp changes) but it DOES NOT save the factory file the way I want it (I am just starting to make heavier use of factory files now so this is why its come up as an issue now)
it seems when I make my changes and save the gcode it saves properly but when I save the factory file either on save or on open I have no idea which it "RE ADDS" default temp controllers and fan set points.
anyway to stop it from doing that?
I tried a work around of GROUPING all the processes except the first process figuring then I can just alter one and it will do them all instead of having to do it 7 times every darned time I open the file :-)
but no. it honors the group change for cooling set points but ignores the grouping for temperature controller. and I have to go into all 7 to remove the hot end temperature controller (it does not readd the bed controller)
https://www.youtube.com/watch?v=UKWx7dImhxU
suggestions?