Top Layer forgotten by simplify3D

[azurha]

Hello o/

I am in trouble !
I have already printed a lot.
After a long break, i re-installed simplify3D.
But simplify3D does not finish my models, it is stop before the top layer, on the all parts, any idea please ?

Thanks :'(

[Squirts]

I’ve been seeing this issue for thin wall on other forums for 4.1, which I’m having the same issue.

I hope there is a fix for it soon. I just bought this in December and I’m starting to regret it.

[jlovett]

My co-worker and I have seen this a couple of times with a print, but only partially. There were gaps in the top layer as if it just didn't generate the .gcode for the finished product completely. I'm not sure why this happened.

[S3D-Alex]

Thank you all for the reports. Can anybody please post a Factory File that shows what they are referring to?

[azurha]

Did you speak about the .gcode ?

[azurha]

up

[dkightley]

Factory file...… File Menu===> Save Factory File.

The saved file contains everything needed to allow someone to load and see exactly what you see when you have your part and profile loaded.

A factory file is by far the most preferred way of allowing someone to see what you're experiencing....

[azurha]

i have the same problem with cura Oo

[dkightley]

Believe it or not......thin walls!

Change the option to allow single extrusion walls....and the missing layer will print. Not very well….but it slices.



Now do you see why a factory file is so important when diagnosing issues????