Ok this is what i am seeing here.. On the g-code tab if i set my z offset to -0.80 the first layer of the print is right where it should be as far as the first layer thickness and also on the wipe pillar. If i look at the live preview however to see what the unit is doing there the layers are not seen on top but are actually being drawn below under the build area. This would be fine if it did not mess with the layer height,as it keeps on laying down the next layer and the next it gets to the point where the print head is plowing threw the first 2-3 layers that it has put down. The print nozzle is not raising up in respect to the layers it is putting down..
This is not a hardware issue but is something in the software.If i take the z offset of -0.80 out and put it back to level 0.00 start a print and then jog the print head down to -0.80 the print works fine layer height increases and the print head goes up with it..but i do not want to have to keep moving the head down to where it needs to be every time i go to print something. which is why i bought this software.
And while it is trying to print the layers the software shows the z is at -0.80 and is increasing with every 0.20 layer it prints to -0.60 -0.40 and then it gets too much built up and is plowing threw the printed layers but the print is still showing z=0..