St0mp
Posts: 5
Joined: Wed Apr 25, 2018 5:28 pm

Simplify3d 4.1.1/ 3dlabprint issues

Sun Dec 09, 2018 3:12 pm

Im working on the PT-17 from 3dlabprint and i am seeing some issues with 4.1.1 On the PT-17 plane top wing part R and L 3 its like a layershift but it only did it to one part so i think its in the slicer sense it did not do it to both parts. they was being printed at same time and i only have the shift happen to one part and not the other?


https://drive.google.com/open?id=1TNsA3 ... JVXlo612Ya


also the top wing R and L 4, and 5 out of noplace its adding outer line?
https://drive.google.com/open?id=1i9UhL ... XDrhJwMfut
this was sliced by 4.1.0 just fine.... the screenshot was using 4.1.1 that blue line that it wants to print is going to be a no go its in thin air and it should not be.

cyborblades
Posts: 6
Joined: Mon Mar 19, 2018 1:56 am

Re: Simplify3d 4.1.1/ 3dlabprint issues

Fri Mar 08, 2019 11:29 pm

I have issues with 3dlab prints as well. If you here anything please post it. I will do the same.

S3D-Alex
Posts: 244
Joined: Thu Aug 30, 2018 1:23 pm

Re: Simplify3d 4.1.1/ 3dlabprint issues

Wed Mar 13, 2019 9:42 am

Can you please post a Factory File showing this issue so we can investigate further?

Return to “Troubleshooting and Bug Reports”