My problem with support separation from part is like that
1. upper and lower separation by number of layers is in my opinion crap. when you want to have bigger layer you are not able to use correctly gap supports. for example I have 0.4 nozle and i want to go with 0,3 layer high, and I must have minimum gap 0,3 with is too big.
2. when Im changing horizintal offset from part it's compensating with upper and lower
for example picture below
https://drive.google.com/file/d/1cpMpcD ... NG5Cv/view
btw program is rly very good, at the moment I have only problem with this supports
