i recently switched my flashforge finder over to a .02mm nozzle and i have done some basic prints to test and ensure the PLA is flowing well through the nozzle. i have the settings for the nozzle diameter and width adjusted to auto so they match for the new nozzle. I am currently trying to print D&D miniatures from Hero forge and i am not sure on the layer height i should be using with the new nozzle. i currently am doing a test print at .05mm for the layer height and am not sure if this is what most people use with a .02mm nozzle when printing miniatures. Any tips or advice for fellow D&D miniature printers out there would be super helpful. Thanks!