Ronald44182000
Posts: 3
Joined: Wed May 15, 2019 10:16 am

Primary width / height less than 1.2 issue

Wed May 15, 2019 10:19 am

I keep getting this response when I attempt to print with PETG in the latest version of Simplify3d and can't figure out how to change the settings. HELP??????????????
Simplify3d.png

S3D-Jake
Posts: 527
Joined: Wed Jun 20, 2018 11:45 am

Re: Primary width / height less than 1.2 issue

Wed May 15, 2019 2:53 pm

Check your Extruder Tab -> Extrusion Width / Layer tab -> Layer Height Ratio. If it's less than 1.2 you should adjust your extrusion width / layer height settings. Typically this means you need to use a thinner layer height or wider extrusion width.
"A bird does not sing because it has an answer. It sings because it has a song."

Return to “Troubleshooting and Bug Reports”