dkightley wrote: ↑
Tue Jun 04, 2019 8:29 pm
I was right.....a basic setup error.
Take a look at the fixed version of the factory file. The differences are obvious....so I hope I don't need to explain them.
I have to be totally honest with you... The only difference I saw was that all of the models were highlighted (selected). When I went into 'Prepair to Print' and Played the preview, the head was bouncing around all over randomly just as it did before when it didn't physically print sequentially. I'm VERY new to this slicer, so you have to forgive me.